Hemi Swapping a perfectly good 70 Duster

racerjoe said
Check out post 197 of my build thread here --> 12:05 Garage- ’70 Duster build

To accommodate the offset for of the top rod where it connects to the z-bar, I just made a spacer to put between the heim and the z-bar. This setup has proven to work great and the adjustability is endless. The long rod has a left hand thread heim on one end to make adjustment as easy as spinning the rod.

Love this car!

Ill check out the rest of the thread tonight.

Question.

The ends of the factory bar have an oblong hole in them, the heim joint ends are round .

Is it a consideration or did you have to make other linkage mods to use the heims?

Thanks for the response BTW !!