Eliminated the Cig Lighter hole and trimmed the DMT Walnut Overlay to fit with the newly made Dash Vent Holes.
Still not the final paint, just primer... I'm going to add in a little silver pinstripe above the cluster to tie the left and right side overlays. The black gap created by the cluster...
So, a little more Dash progress.
Had to repair the radio cutout, a previous owner had enlarged the center hole a bit but not in a way that worked with my plans. So I repaired that first then cut out an opening for the Pioneer MVH-S720BHS single Din
Mech-less (No optical drive) unit.
When I was...
Sold all of them...
had a pretty good sales total for the weekend despite not having the best weather or turnout. A success nonetheless.
Also was contacted by a kid I gave my number to, that is going to buy my 6.1 intake manifold.
Small sample of what I'll have at the swap meet this weekend. 67, 68, 69 Barracuda Fastback back seat emblem. Come to the swap meet and buy one or all three. ;-)
2017-18 Challenger console modified to fit Classic Auto Air Controls.
Had considered upholstery for the new finish but concerned that the compound curves would require some serious stretching and no way to hold the edges from pulling back if I trimmed it inside the trim ring and I didn't want to...
Ididit Tilt Steering column with incorporated EPAS Performance Electric Power Steering motor and PCS paddle shifters test fit together with the new gauge cluster. Line of sight seems pretty good.
It's hard to tell exactly where the seat will be without the gas and brake peddles installed. But I...
Usually, I will opt for machine screws but I had these handy.
Considered finding and swapping but don't think it's really necessary.
Grinding the points off is a good call.
I switch between my factory 70 340 air cleaner and this one.
I am certain this one flows more. But I like them both a lot so I change them back and forth.
Maybe if I chromed this one, it would be even faster. "¯\_(ツ)_/¯"
Just test fitting it here in this picture.
I use plumber's putty to check...
Well, so here the cluster is just held in with some tape. Was thinking about how to fasten the 2 together.
Had several thoughts about brackets, bending metal, nuts and screws, etc.
Then I kind of had an epiphany of sorts... Really very simple and using hardware I already had.
These were all I...