Big thanks to @johhnymac , and the folks over at blueprint engines had a tired really bad 360 in the car ( 1973 duster 340 car ) the folks over at blueprint engines really built what looks like a quality product they painted my block orange like I wanted, it hasn’t been installed yet but I can...
“Performance wise, it is tame enough to drive daily but has enough power to light the tires at any time.”
wow thank you for the info I’m also using a 904 with b&M flex plate hearing that puts me at ease of worrying the motor is too radical for a street drive to the local car show or cruise.
If you don’t mind saying which version of the 408 did you go with ? I am currently shopping for a crate engine have several companies in mind like you I’m more of a cruiser kinda person having a tough time deciding thanks
thank you sir I will look at the Larry sheapherd book again and look over the six pack set up that may work for me and substitute it for air gap and 750 dp. Carb.
The pistons are sealed power hyp. 405cp., @rumblefish360 I wanted to get the motor sorted out first it has the 3.23 gears in it because it was a good deal at the time and I needed it to be a roller to move around , however the 3.91’s will be going in once it moves under it’s own power and I’ve...
Thank you very much for the assistance I forgot to mention it’s on a 73 duster 340 car didn’t wanna mess with the #’s matching motor , I also have installed the offset shackle kit and it’s got 275/60/15 under the rear. Was thinking about using the comp cam xe274h cam?
Nothing magical just wanted a decent driver that’s not a dedicated race car. I think those number for me are realistic with the parts and budget I had in mind? I’m always open to opinions and suggestions I normally don’t post much on here but do value the knowledge of the people on this site , I...
63cc chamber, up to .580 lift cam pump gas premium I also have access to 100 octane if needed the plan is to drive the car to local car shows and the occasional 1/8 mile run the valves on the head are stainless 202/160 with Hughes springs rev range 1800-5000ish
Good day hopefully y’all can help me with my cam selection I have enough knowledge on what to buy but am not sure and don’t want to make the wrong selection. I was thinking of a hot street engine not daily driven raced occasionally.
360 bored .60 over zero deck height stock bottom end
Ootb...