66fs's latest activity
-
66fs replied to the thread K-frame alignment?.There used to be a tight, close tolerance hole and a tight tolerance slot so the K frame would self align. If some one opened up that... -
66fs replied to the thread Valve adjustment........LOL You think I'm intimidated by you? Never. You have not contributed anything I thought was interesting, let alone anything I did...
-
I was kidding. I couldn't care less how people adjust their valves. If you finish and it's running right, that's all that matters.
-
Check out the early A-body builds by @Jim Kueneman . He's got meticulous photos of the door internals of the early Dart and Valiant he...
-
66fs replied to the thread Valve adjustment........LOL Your posting your stupid opinions on a slant six forum about adjusting valves on a stock 74 slant six. All the while spouting your...
-
7 1/4' not too weak for a 318.
-
Yes
-
Funny! My dad showed me to put a screwdriver onto the tip of the stud and the plastic part of the screwdriver in my ear. If it...
-
66fs replied to the thread Valve adjustment........LOL even a slant six guy can do it. Did it that way since I was 19 and that was a long time ago. Did it that way at the dealers on a...
-
I don't think I'll be able to sleep tonight knowing that people are adjusting their valves with the engine off.
-
I should probably be committed in some kind of mental asylum as soon as possible.... :lol: I've been hangin around the "trailer trash"...
-
8007
-
Absolutely. I think we have enough evidence right on this thread that Chrysler made them both ways.
-
Unported 906’s with SBI replacement valves, good valve job with bowl cut, milled to about 77cc, dual springs. Flowed low-230’s. TRW...
-
FWIW, I don’t mind 383’s at all. The few I’ve built have turned out pretty well imo. My view on a stock type rebuild is this……. You’re...
