Recent content by gg408

Thanks for that info. I will certainly rethink everything I was lead to believe when told to use them.

Spring pressure are both the same on intake and exhaust. Not sure if I should have little more on intake as it is boosted. Valves are 2.05" in & 1.65" exh , 11/32 stem with tool steel retainers and AFR/PAC springs. Waiting to see what cam company has to say.

If I could I would run 3/8"pushrods but room is tight.

I was also concerned about that but was led to believe it would be ok. No marks on the lifter bore bushes but haven't seen anything over 4000 rpm.

Plenty oil going to lifter. If I could up load vid you would be amazed out how much oil flows past the lifter.

That’s getting checked now but I would have thought if that was the case why all intakes have same witness marks and exhaust are ok.

No just the intake.

Oil hole size is .059”” Have taken the cam back to the grinders. All intake lobes have the same markings , only#2 & #8 intake lobes are damaged.Maybe I caught it in time before they all become like that.

Has a thrust plate.

Thank you all for the replies. The damage on the lifter is on the opening side of the ramp just before the top. The lifter bores where bushed for flat tappet solid lifers that measured .904"and these BAM lifters measure .903", so the clearance is about .0028" atm with the BAM's. Spring pressure...

Hey the peeps. Have a set o BAM solid roller lifters in my SBM with .180"offset pushrod hole on the intake. Recently damaged 2 intake lobes and the other 6 intake lobes have the same witness/wear marks. Was wondering if the pushrod offset could be causing this issue. Has anyone use offset...

Hey people. Just a quick question, does anyone know if you get get of the shelf turbo pistons anywhere to suit 410 small block stroker? Cheers

Yes I understand that but the valve body itself still has the provision for the supposed kick down lever to be put back on. I have never used a TCI valve body before. Plenty times the Cope one.

Hi there, Can some one tell me if on a TCI full manual reverse pattern valve body part # 121700 the kick down lever should be fitted? Came out of old trans and no instructions so not to sure and cant find much info on the web. Thanks in advance.