Recent content by 72dds

thanks for the replies and the pictures. just heard from koffels as well and they said you can drill approximately 3/4 of an inch there.

I called Brodix and they sent me over to koffels place. Waiting to hear back from them. It looks like there is extra material on there for this purpose but don't want to make an expensive mistake.

I have a set of B1BA heads on my 360 and need an accessory hole drilled on the driver side head for my procharger bracket. Does anyone have experience with this? How deep can it be drilled?

Thanks! I have been using a wire wheel wherever I can and sand paper in tight areas. Going to close up some of the holes in the firewall then primer/ paint the engine compartment.

Making a little bit of progress, Got the RMS suspension delivered, along with brakes and wheels. Just got to do some metal work before i bolt it all together and have it sitting on all four tires again! Rear end needs to be moved back a little and it will be all done.

Wasn't a huge fan of the mini tub kit, mainly because the filler peices didn't want to match up properly on both sides but it works. Tires are 325/50 15. They fit so far, I'm hoping the rear ends comes to exact measurement so I don't have to do anything.

Brodix heads, Comp cams custom cam, edelbrock rpm intake, harland sharp 1.5 rockers. haven't ran it yet, just had it built. the 9" will have 3.89 gears to start out with and see how it goes.

Bought myself a 72 swinger couple years back with the intentions of doing building a 10 sec weekend toy. It's definitely taking a while to learn what the right parts are and how to, but it's fun to start with something basic and build it into what you want. Bought it for $1500, came pretty...

grille? or bezels? how much?

Looking to buy 72 dart grille and/or headlight bezels. seem to be few out there just hard to get a hold of them. ones on my car were very damaged when i bought it.