Recent content by Rocket

Make sure everything is clean from the oil passages to the shafts to the rockers, to the adjusters and out the back of the rocker. Things can get gummed up, ... over the years.

If you can’t find any here, Dr. Diff sells them.

I am looking for a few Eagle small block H beam connecting rods in very good usable shape. PM me with what you have. Thank you

Stock 273 rockers had a hole drilled right through the adjuster casting and into the rocker so oil would flow sound the threads and dribble down into the cup. For higher rom operation one modification was to brace the back side opening so oil would be forced down the threads and into the cup...

I may have one. Clear your inbox.

I have several ignition parts for sale. Prices include shipping in the lower 48 states. I will ship internationally for the added cost. New MSD Digital 6AL ignition module part #6425 $290 shipped Used chrome ignition box $55 shipped Used coils. Jegs $35 shipped PM me with any questions.

I have a new set of 8 Mopar Performance pistons and wrist pins Mopar part# P4876973 for a 3.454” stroke crankshaft. Specs are 4.060” bore, 1/16, 1/16, 3/16 ring set, 0.984” wrist pin, flat top with ~ 5 cc eyebrows, listed by Mopar as 10.5 compression ratio. Compression height is ~ 1.72” per my...

I have two sets and 4 spare BBM used main cap sets for the 2.75" crank journal. See pictures below. $40 a set or $70 for the who lot shipped in the lower 48 states. I will ship elsewhere for the added shipping cost. PM me with any questions.

I have a new set of 16 new Erson big block Mopar roller lifters in their original box. These are 1.6 ratio and have needle roller bearings that ride on the rocker arm shaft. These rockers are USA made, and are very strong and are well constructed. These rockers use an 11/16” hardened shaft that...

I have 12 new Mopar Performance 1.5 ratio roller rocker arms for W2 econo heads. This set has the 8 exhaust rockers and 4 left intake rockers. Left intake part number is P4532859 and the Exhaust part number is P4532860.I do not have any right intake rockers. $520 shipped in the lower 48 states...

I have a set of New BRC 4.030" forged flat top pistons and pins for a 3.79" stroke small block crankshaft. Compression height is ~ 1.57" and the ring lands are 1/16, 1/16 and 3/16. 0.984 wrist pins included. Approximately 6cc valve reliefs. These pistons can be used in aftermarket race blocks...

I have 11 pairs (one complete engine set plus 3 spare pairs) of new Mopar Performance solid roller lifters for small block Mopar race blocks still in their packages. I took one pair to photograph. Part number is P5249584. See the included picture from the 1997 Mopar Performance catalogue for the...

The track use to be called Cayuga Motor Speedway which is the name of the town the track is located in. Anyone know why they changed the name?

I will take it. PM sent

Any exhaust lobe wear indications?