3g Hemi Checklist

Hey guys, I'm currently making a list of items to complete my 3g hemi conversion.

So here is what I currently have:

07 Charger Motor with all accessories
09 6 spd manual Gearbox from Challenger with bellhousing, flywhell, clutch
Milodon sump
TTI Engine mounts
WIX FUEL filter #33737
Drive by wire pedal


I am trying to work out what else I need, this is my list so far:


Wiring harness from S&P
Fuel pump and lines
Oil filter block off plate + oil filter relocation setup


I'm just trying to see what other things I may be overlooking?? I'm getting this all sent to a pallet over the next month and shipped back to Australia.

Headers (S&P or TTI's) or Grand Cherokee srt8 exhaust manifolds, maybe?

Got a slip yoke for the trans? You'll need a high pressure fuel system, too.

Buy your harness from Hotwire, they also have all the extra's you need (DBW gas pedal, etc.)

Slip yoke etc for trans I think I will secure over here. I forgot to mention but have altered my post now that I do have the drive by wire pedal already.

I'm not sure on clearances yet for the headers/exhaust, Has anybody got away with using stock LX car manifolds?

For the fuel system, other then the filter/regulator, I think I will modify the existing tank with an intank pump. Whats people's recommendations on fuel pumps? Other then those items I basically just need to run lines and fittings that is it?

Also, will the starter motor that came with my motor (5.7 auto) work with the challenger manual transmission? I asked over on the challenger forum and someone told me they are the same starter motors. I just wanted to confirm this as I see manual starters for sale on www.hotrodlane.cc site and it made me start to wonder.......

Where did you get your throttle position sensor from. I got my harness from hotwire auto.