Tube bending

Hey guys, anyone have a tube bender or know of a place that can bend some tube for cheap? I have 3 pieces 5' ea. of round 1-1/4 /.065 t.s. They all get bent the same on ea end with a 3.5-4.5 r at 80 degrees with a 4" leg or so. I have a cad drawing and have accounted for the material at the bend so all should be straight forward.

As always thanks for the help.
Joe

If you are near Apache Junction might want to try ADD (http://addictivedesertdesigns.com/)

I had a friend use ADD for his jeep bars. Did good work.

I had a friend use ADD for his jeep bars. Did good work.
Jared is a good guy. His Dad is my transmission buddy.

What area of the EV are you in? I am on Meridian & Southern just behind the American Legion.

What area of the EV are you in? I am on Meridian & Southern just behind the American Legion.Was this for me?? If so I am not there anymore. I used to live between Brown & University. 80th St. was right behind us. If you go down 80th St. look for the place with a garage right on the fence line, I was right next to him.

it was yes.