64physhy

I have the engine bay painted, and the floor pan all finished and painted (w/ 4 spd hump in place). Leanna has the v8 front suspension with her, and Brian and I agreed on pushing out the engine until October time frame. I have lost the garage I was using until mid October, so the car has been put into storage until then.
Currently I am blasting and painting smaller parts, and looking for part time work on the side to fund the completion of my baby!

Temecula car club?

Dave,

Let me know when you are going to pick up the engine and I will try and head out there with you. I am ready anytime for Brian to start the machining on the new engine and he needs to upgrade the set of RHS heads that I have for a Solid Roller Cam.

Let me know.

951-265-8140 Cell email is louis@frdmmtg.com

Louis

If our schedules don't line up and you need to use my stand you can no problem.

Hey dude!

Saw you roll by a couple times tonight on Grand! I didn't have the Duster out tho! Did you see the post about Grand on the 17th. (in the West coast section). Going to be a bunch of FABO members there...You should come out man!

Hi 64physhy.

I'm slowly, very slowly, building my stroker and will be using the same cam as you (solid flat tappet not hydraulic) with stage 3 Hughes eddy heads, air gap, kevko sportsman pan, K1 forged internals, Hughes rockers, etc etc
Oh an the EZ-EFI instead of the carb!

Have you got a figure on your hp and torque yet. I am quite curious what it will make as it will be a very similar setup.

Have you checked out these guys www.iceignition.com
Thats who I am using for my inginition system.

All the best,

Brett