1dirtymopar's latest activity
-
1dirtymopar replied to the thread 1971 Duster Lower Radiator Support Measurements.@Oldmanmopar Thanks for that info, the k-member should be good and straight (or so I hope) as I switched from the original /6 to v8... -
1dirtymopar reacted to Oldmanmopar's post in the thread 1971 Duster Lower Radiator Support Measurements with .Hold the top using a metal brace . Then spread the bottom with a porta-power and weld. Do this with a straight K-member bolted in...
-
1dirtymopar replied to the thread 1971 Duster Lower Radiator Support Measurements.Managed to do some quick measuring. The top of the frame horn comes in right at 34 5/8 while the bottom is at about 34 5/16.
-
1dirtymopar replied to the thread 1971 Duster Lower Radiator Support Measurements.Thank you @Oldmanmopar I appreciate it. @Dana67Dart I'm going to have to look at mine again. @glenn340 Thank you for that picture on...
-
1dirtymopar reacted to Dana67Dart's post in the thread 1971 Duster Lower Radiator Support Measurements with .That was what you were looking for, right? Not my car just a net photo niti g where I measured I have a stripped 67 dart in the...
-
1dirtymopar reacted to glenn340's post in the thread 1971 Duster Lower Radiator Support Measurements with .My 1971 Duster... don't believe it has ever been hit. Drivers side is definitely wider than passenger side. Measures 26 1/4" looking at...
-
1dirtymopar reacted to Oldmanmopar's post in the thread 1971 Duster Lower Radiator Support Measurements with .This may help the width are the same as a Duster or demon
-
1dirtymopar replied to the thread 1971 Duster Lower Radiator Support Measurements.Thank you for that!
-
1dirtymopar posted the thread 1971 Duster Lower Radiator Support Measurements in Mopar Body and Trim.Looking for a few measurements if anyone has them available or can assist. I'm in the process of replacing the lower radiator support...
-
