Recent content by 360tripleblack7

More pictures..

Hello Guys, sorry for delay but finally I got the heads flowed. I'm very satisfied with results. 208cc intake runner 2.53 MCA 2.08 intake valve 4 angle valve job 65cc Combustion chamber 4.000" bore measurements

Inbox are cleared. Thank you.

Part Number: 60775

SB Mopar Harland Sharp 1.6 Full Roller Rocker Arms + Mopar Performance Billet Hold Down Kit. Used, but in very nice condition. Rockers Part Number is S70026K. Price just for rocker arms new at Harland Sharp is $837.00. Asking $650.00 + Shipping for Rocker Arms and Hold Down kit. Located in...

Small Block Mopar Performer RPM Heads Stage 2 ported by Ryan Johnson from Shady Dell Speed Shop. • Fully reviewed (Valve spring pressures, height install, valve lapping, valve guide clearance). • 4 angles valve job • 2.02" intake valves / 1.60" exhaust valves. Both with 30° back cut • New Comp...

Like a new, that Super Victor was fully ported and gasket matched for Edelbrock 7276 intake gasket (2.30" x 1.17"). Located in Tiffin - IA. U$: 650.00 + Shipping

Yes man. I have heard about the "Bad reputation" around these heads and that they don't give the real power that they should. I'm spending a lot of time on measurements to calculate and correct what I think that is wrong on these heads IMO. I'm doing a huge porting work to try make this heads...

Thanks Johnny. I need to finish some details on intake runners and work on combustion chambers. Hope that I can flow them in two weeks.

Yes Rob, 193cc. Flowed [email protected]" and [email protected]". Edelbrock 6077 head with 2.08" intake valves that is currently installed in my 360" engine. The plan is replace these Edelbrocks for the Super Commando that I posted the pictures above. I would like to measure the intake runner volume tonight.

Hello Guys, Some update on intake runner of Super Commando Heads.

Sorry for confusion Johnny. I flowed [email protected]" on current head that is installed on my car this heads has 2.08" intake valves and was flowed using 4.000" bore size. I didn't flowed Super Commando yet but I will keep you informed about the number as soon as I have. Here is a picture of my head...

Thanks Johnny, PN is almost the same. Mine is a little bit different then yours. On the front of head has the PN P5153850. This must be the PN for a assembly head and P5155128 would be a bare head. I made some tests in my flowbench using different bore sizes to understand how the bore size...

Thanks guys. Mine has 2.08 / 1.60, 11/32 valve steam. 5/16 rocker bolts and same size of intake and exhaust runners. Basically is a Edelbrock head! I'm running currently on 360" 3.58x4.000, 11.8 CR, Pump Gas, Solid Flat Tapped Cam, Tunnel Ram and with a set of Edelbrock ported by myself that...