Hey Derek! Happy Birthday bud! Hope you treated yourself to some mopar donuts.
If you crossthreaded a screw, rocker threads may be pooched as well. Both I think are available individuallyGood eye,yes i purchased a full set...
Price is $3000 Canadian. We can load a shortblock in the back of the truck.
Yes. Notches down. Pass side to the rear and drive side to the front
Yep I agree, that's why I was 2nd guessing the notch orientation initially stated and checked literature I had. I was sure notches were down on...
Yep thanks for confirmation, chamfers out! Didnt check side to side clearances on rod as plastigage would have smeared.
Sorry i misunderstood, I thought you were asking about front buckets.
I have a 67 notchback rear seat if you need measurements.
Why can't damn fsm get terminology right?
Calling it "left bank" or "right bank". WTH... Call it drivers side or passenger side.
Even 2 mopar sb...
Actually all even numbered rod caps should be the same as this one, correct?
Quick question. If i understand the book correctly, the rod cap i took pic of is for #2 correct? Large chamfer to rear of engine?
I installed #1...
67 seats cosmetically are different
Now those are cool!
I was thinking clearances would be same. Maybe I'll put it all under the Christmas tree to warm up?
Thanks for the kind words Larry. Seeing the grandbabies grow up and interact with each other is truly a blessing.
Winter could be worse....we...
When I measured the id of rod bearings, I did it with bore gauge then measured gauge with verniers. Then I rechecked that measurement with using...
Separate names with a comma.