Recent content by 68383GTS

  1. 68383GTS

    [FOR SALE] Small block overdrive bellhousing

    Small block overdrive transmission bellhousing. In very nice shape. $275.00 plus shipping from East Peoria Illinois
  2. 68383GTS

    65 Dart questions

    And a canopy vinyl top
  3. 68383GTS

    65 Dart questions

    It has the three rectangle chrome pieces on the lower fender and door on each side
  4. 68383GTS

    65 Dart questions

    Going to look at an original 1965 Dart 2 door hardtop.It is a slant 6 automatic car. It has factory bucket seats and a floor shifter. So does this make it a GT or bucket seats were just optional?
  5. 68383GTS

    [FOR SALE] 1984 D150

    $4700.00
  6. 68383GTS

    [FOR SALE] 1984 D150

    $5000 or Mopar trade
  7. 68383GTS

    [FOR TRADE] Clean 84 Dodge D100, Illinois

    I cleared out my mailbox
  8. 68383GTS

    [FOR TRADE] Clean 84 Dodge D100, Illinois

    Possible trade for a project car and cash
  9. 68383GTS

    ? For those who have recently bought or sold a vehicle

    I sold a 70 Road Runner for a lot of money. The Bank told me there are only two safe ways ..Cash and a check it with marker. Or bank to bank wire transfer. I used the bank wire and the money was transferred right in my account. Do NOT accept a money order or certified check those can both be...
  10. 68383GTS

    [FOR SALE] 1984 D150

    Also new calipers and brake pads.
  11. 68383GTS

    [FOR SALE] 1984 D150

    1984 Dodge D150. Clean KY truck. Slant 6 4 speed.Slant 6 has been replaced with a reman engine mileage unknown.Engine uses no oil. 4 speed works good but the pressure or throw out bearing makes some noise at low speeds. New shocks,tires,throttle cable,carpet,carburetor,and electronic distributor...
  12. 68383GTS

    So any good cam and lifters out there?

    I know how to install and break in a cam. Just worried about the many manufacturer lifter issues.
  13. 68383GTS

    So any good cam and lifters out there?

    I would like to replace my 484 purple cam in my 383 this fall. With all the lifter issues out there the last few years I don’t know if it’s a good idea. Has anyone had any luck with a new cam and set of lifters lately? Maybe I should look for a NOS set from the 90’s….lol
Back
Top