Recent content by 70duste

link about ez grease bearings i don't think you should put 1 tube of grease in each wheel, i don't think the grease seal can stay in place and not leak grease onto the brakes, 9 times out of 10 its the outer bearing that fails from lack of grease ,my trailers have the EZ grease set up and i...

95 should have a 12 valve cummins 24 valve came out in late 98 or 99 trucks being a texas truck it would be rust free and worth doing a cab swap to get it back on the road, i guess at 76 years of age i probably wouldn't want to take on a cab swap either.

I would put a different cab on it and drive it not that hard to do a cab swap

well i did, but not anymore! thanks.:lol:

i would think so ,leave the valve covers off would help. does car have power steering?

problem solved!! did more testing, and found if i blocked #4 injector line off the truck would start right up, did this to all cylinders and tried starting after each injector was blocked, truck would not start until #4 was blocked off, ordered all new injectors,connecting tubes,and fuel lines...

no glow plugs cummins use a intake heater, which is new .

ok guys i did some more testing and found if i block off fuel lines to injectors individually when i get to number 4 injector the truck starts like it should.when its blocked off so im trying to decide on what injector kits to buy???? probably should replace all 6 injectors, but dang they are...

i have owned truck for 4 years and have put on 30k miles. i have not adjusted the valves

hi, i have not used ether to try and start it, yes i use the blended fuel and have not had any problems with jelling. this weekend i put a new heater grid in on saturday sunday morning it was 30 degrees ,truck was not plugged in and it cranked for20 seconds and started up, i was surprised!

185000 miles yes it has a k&n filter, its a 5.9 auto 4x4 3500 ram

hi, thanks for the reply, i had one prv on another engine that i swapped to mine and it did not change the no start, but i don't know if that prv was a known good part i swapped. ill check it out tomorrow,by cracking the line while cranking and see if i have fuel coming out. thanks

j body??

hi guys i have a problem with my 2004.5 325HP dodge ram Problem is when it is below 50 degrees outside this truck cranks and cranks sometimes it starts but most times it wont, i have a DRB3 scanner and have checked the following 1. no codes 2. fuel pressure from lift pump 23psi to 30psi while...

ok