Recent content by Barracuda67

Any online research shows there are 4 numbers after dot. Last 2 are supposed to be the year. So if they are week is 00…??

Wondering what manufacture supplied tires for the 1967 Barracuda? I still have the spare that come in it when I purchased the car. It is a BF goodrich belted TA. P215/70B14 DOT bdhy700071 So is that a TA from 1971?

Been awhile. What I miss?

Well it is multiple problems. dash light, high beam and signal are working now. found light switch and plug with corrosion on pins. cleaned up and fixed that part. then unplugged everything I get my hands on and checked and reseated. Appears there must of been some dampness got in there a...

I have problem with my dash electrical. I have no turn signal indicator lights, no high beam indicator, no dash lights, no temp, no oil pressure, no gas gage. have had dash out couple times trying to resolve this with no luck. (it has been like this since I purchased the car... 20+ yrs ago...

OK. Thanks guys. Someone asked me and I just didn't know either.

Thanks, but ... what part? The bell?

Is the trans. the same for a Big Block and Small Block engine?

I still use the original style alternator with the diodes and external regulator. Rebuilt by a local ($40) and no problem since.

I agree with dodgetkboy.

Thanks. It is unknown what or what year the set of 323's I have. I keep my fingers crossed.

My suregrip was a factory install. I didn't even know it was for years untill I went to change the oil and it even still had the suregrip tag on the cover bolt. And I'm still wondering how interchangeable the 71/4 maybe?

So does anyone know if pinions and rings are interchangeable through the years and different gear ratio's? Thanks

I have a 71/4 rearend in my Barracuda with a factory installed sure-grip. Gear ratio is 276 - I want to install a set of 323's and pinion that I picked up. Question. Will the 323's bolt up to the sure-grip with no problems? I have already purchased new bearings complete and proper oil and...

Ok... Thank you all for your feedback. All good. A little detail on engine spec. I rebuilt this engine approx 1yr ago. 40 overbore but only piston available to me at that time were 4-valve relief slugs with a concaved (dished) top. Mech. Cam and lifters and matched springs from comp cams...