JPAR
Thanks for your thoughts, however, for my build I have already planned and budgeted for a shop to perform this work.
You are correct in the assumption that I don't have the space and very limited time. With starting a family my time will get less and less for this so I would rather have...
Hello,
Does anyone have a recommendation for a transmission builder near Portland Oregon?
I dropped my 727 small block with some nice parts off with A1 Performance 5 weeks ago, and they are requesting another 3-4 weeks to complete it. They were upfront with me about their lead time (6 weeks...
I currently have a 72 Duster, I ordered and installed a Hotchkiss suspension system TVS for the 68 thru 72.
During the installation the sway bar wouldn't fit. After looking at the engine mounts it was assumed that somebody during it's lifetime had swapped a 73+ front K Member. This would also...
Selling a set of Schumacher BB Conversion Headers in Chrome, Brand New in Box.
Asking $600 shipped anywhere in the lower 48. Accept Paypal.
These are the HC Chrome that retail for $695 shipped, but they are currently out of stock.
Relist due to Buyer not making payment.
This is a conversion for B Block to a single wire alternator.
Comes with Alternator, bracket, and hardware. This is a v-Belt style so you can keep your current accessories.
Asking $100 Shipped to the Lower 48.
Accept Paypal.
Selling a set of Schumacher BB Conversion Headers in Chrome, Brand New in Box.
Asking $600 shipped anywhere in the lower 48. Accept Paypal.
These are the HC Chrome that retail for $695 shipped, but they are currently out of stock.
Selling a set of Schumacher BB Conversion Headers in Chrome, Brand New in Box.
Asking $600 shipped anywhere in the lower 48. Accept Paypal.
These are the HC Chrome that retail for $695 shipped, but they are currently out of stock.
Bob,
Yes the Mag checked out for the block and heads. The bores will need to be cleaned up, I'm not sure what that entails.
That being said, I'm not interested in shipping at this time. Done that previously with a block and wasn't worth it.
Selling a 400B Block (+.030 Over bore, magnufluxed), 383 Forged Crankshaft, Rods, and Pistons. Rocker Assembly and 452 Heads (Magnfluxed and with original valves and springs)
Asking $200, located in Newberg OR
Not willing to ship at this time.
Looking for an Aftermarket Intake Manifold to finish my budget minded 440 Build.
Looking at any of the following, ordered by preference:
Edelbrock RPM 7193
Edelbrock 2191
Edelbrock Torker II 5091
Please let me know what you have, located in Newberg Oregon
For Sale: Dodge 8-1/4 Rear End I removed from my Duster (Upgraded to Dana 60 for Big Block)
Unknown Ration based on previous driving should be 3.21. Assumed Open Carrier. 5 x 4-1/2" Bolt Spacing, Wheel Spacers on ends. Can come with the springs if the buyer wishes (Stock A-Body).
Looking from...