Recent content by bryan Schaupp

  1. bryan Schaupp

    How To Replace your Lower Column Bearing: Better and Cheaper!!!

    mine if i remember correctly had clip on originally best regards bryan
  2. bryan Schaupp

    [FOR SALE] 1967 fastback formula S clone 383 automatic $45K Mora, MN

    For sale 1967 Barracuda fastback: 1.03 torsion bars 383 727 8-3/4 with 3:23 sure grip 842 Nice Black paint - SS A pillar trim, SS window trim summer special gills w/Cadillac spears (SS) AC - tested & charged - 300 switch not turning on compressor - was waiting for 68 dash completion to bench...
  3. bryan Schaupp

    1967 Barracuda Formula S upgrade restoration

    Nice car should be great project
  4. bryan Schaupp

    Wiring turn signal brake lights

    Thanks, have checked at junction will keep playing with it. may wait until switch over to stock dash to see if helps. Emergency flasher plug can go in 180 off not sure it it would cause problems or not? Has anyone had to switch around or ran into same problem?
  5. bryan Schaupp

    Wiring turn signal brake lights

    I do get fluctuating charge reading. Which tells me it should be working. I moved assembly that works (right side) over and one on this side to right side and still drivers side not working and passenger works?????
  6. bryan Schaupp

    Wiring turn signal brake lights

    I have read this and put extra grounds to make sure currently switch lamp from left to right to make sure nothing in socket
  7. bryan Schaupp

    Wiring turn signal brake lights

    I replaced it as I have read a lot of times this is the problem area.
  8. bryan Schaupp

    Wiring turn signal brake lights

    I have factory manual for valiant wiring. All seems good there. I bought sockets that have their own ground. It is 1967 Barracuda fastback. I put meter to plug for socket and get fluctuating reading (set at voltage DC) which seems like should be good. I will double check soct or use one from...
  9. bryan Schaupp

    Wiring turn signal brake lights

    I am hoping someone ran into this before. My drivers brake light and right turn signal not working Regular lights work Emergency flasher work on all three other corners Brake light works passenger side Put in new turn signal switch (heard that is sometimes problem) I see in schematics it is...
  10. bryan Schaupp

    [SOLD] 68 spring special grille inserts 1967 rocker trim

    I have following hoping to trade for 1968 rally dash tach reproduction is fine: 68 grille inserts - spring special drive condition 1967 formula S rocker panel trim - will need polishing but nice otherwise - one has anodizing looking poorly
  11. bryan Schaupp

    Torsion bar install

    The ride is nice on my car not harsh at all. to the point maybe should go with even thicker but think these will be good compromise
  12. bryan Schaupp

    Torsion bar install

    I just made one out of scrap aluminum drilled hole little smaller than the torsion bar used fr or you could just put v in it if you have means.
  13. bryan Schaupp

    Torsion bar install

    bryan Schaupp submitted a new Article: Torsion bar install Read more about this article here...
  14. Torsion bar install

    Torsion bar install

    I read a lot of conflicting information prior to changing to the 1.03 Bars. When all said in done it was pretty easy, Here are steps I used: 1. Jack up car so front tires are off the ground and support with jack stands. remove wheel tire for easy access - picture #1 2. Loosen nut for lower...
  15. bryan Schaupp

    [SOLD] 1968 AC dash/bezel/cluster-fairly complete barracuda

    I am going to see if I can sell as unit first I will let you know if I change my mind. Thnak you. Bryan
See more
Back
Top