Thank you for getting back to me on the pulleys. I'm trying to make sure everything will line up with the a/c unit that I have. It is a classic auto air unit. The pulleys I have now are from march performance the front belt runs the a/c and p/s. The back belt fan and alt. All are single v,crank...
looking for overdrive crank and water pump pulleys for 68 340 barracuda. Water pump outlet on drivers side. This is a after market a/c from classic air unit. Car runs cool when driving down the road but when it sits and idles temp goes up. I don't think it is pulling enough air with the under...
You need to check the distance I just bought a cold case with the electric fan and did not have enough distance for it to fit. You need at least 6 3/4 inches for it to fit or a little more had to send mine back to jegs.
I got the borgeson box and love it. I did cut 1/2" off my shaft but after I found out there is a coupling that will work with it so you don't have to cut the shaft. It is in one of the threads on here.
The only problem I had was one header pipe was hitting . I am running dougs headers 1 5/8. I tried to dent the header but was not able to. I put a 1/4" shim under the driver side motor mount it worked out fine. I love the gearbox like driving a new car.
Had the same problem with my 68 cuda . I checked everything under the car all was tight. Then tried to adjust the steering box no luck . Bit the bullit and got a borgeson box from summit. The car now drives like a new car.
It's close but not hitting
Yes, before I had to steer with one hand and move the steering wheel up and down. If you were on an uneven road it got to where it would dart. So I bit the bullet and went with the borgeson power steering box. I love it I can drive it with one finger on the wheel even...
I got my new borgeson steering box installed. It is like day and night in the handling. I jacked up motor on driver side and pulled old box out from the top after pulling the header. I had to shim the motor mount 1/4" to get some clearance with the dougs headers. Cut 3/4" off the steering shaft...
installed new borgeson power steering box. Driver side dougs header was hitting box. I shimmed motor mount 1/4 to get clearance. Any concerns with this? Thanks 53