Recent content by DavidLee

super gas?

for sbp?

i still want the capacity to use one.

I went down to HF and thought I could use their inexpensive wall mounted air regulator since the 10 year old one on my porter cable air compressor finally bit the big one. The HF POS was defective right out of the box. Its going back tomorrow. I guess going cheap was real stupid on my part. I am...

if the other buyer does not want it, let me know asap

by whom?

i am going to have my panel replaced in a short period of time. I will just ask them to add a few more plugs into the garage. That will give me an excuse to clear the garage and paint the floor at that time.

my brake system would not have any pre-bent brake lines. going from a Willwood valve with 37 degree an fittings to a line lock. Then entering the wheel well directly.

I have a standard 50 amp 220V socket that I have used just for my miller mig welder. My garage is the typical garage that was built in the 50's that came with just two 15 amp 110V plugs. I would love to have a converter that i can then wire some extra 110V sockets. What would you recommend?

also has anyone used Nicopp brake lines?

accord to eastwood the bender wil do SS, but i may step up and get a better one from imperial

Triple Head 180 degree Tubing Bender 3/16-3/8 in Eastwood Professional Brake Tubing Flaring Tool Thanks

$60 plus shipping

Looking for one of these

ok, i ill pass i need two