Recent content by dboldt

Looks like $200-275 range.. would have to inquire about packaging.

I'm open to that if they'd do it. I hear Fastenal is pretty good. 3PL (Third Party Logistics) | Fastenal

Genuine Mopar 1967 Plymouth Barracuda Bench seat. It was restored 5 years ago by legendary interiors in nearby Newark, NY. Not a cheap date. It was torn down to the bare frame, any springs that needed welding were repaired, and it was repainted. All new padding, burlap, springs and factory...

Who’s going to Chrysler Nationals at Carlisle this summer?

www.steeringwheelbob.com does a great resto job.

Nice car. Any pics of the engine compartment?

Awesome! I was talking to you about your bucket seats.

First time for my cuda too. What did you bring?

Who's all here at The Nationals from FABO? Check in on this thread with a post?

3M Super 77 spray adhesive. Takes a little while to set up so you can work with it. Easy to remove down the road if you need to revisit.

My car was born with a bench seat, but I scored a pair of proper 67 cuda bucket seats at Carlisle a couple weeks ago. This post was exactly the info I was looking for.

Doesn't seem like much is available with a 5" BS on a 17x7. Most mainstream options are all 4". I'm in the same boat. 73+ BBP spindles, looking to keep a 17" off the fenders.

Here's a few more pics. Had a few rules for this install. No holes. Nothing that cannot be easily removed. (except for the dynamat) Still needs a few trim pieces and a door/piano hinge in the floor. Will keep microfiber towels, etc in the spare tire hole.