Minnesota sucks too!!!! Law enforcement around here in the outsides of the metro area is awesome but there hands are tied by the sanctuary state the democrats have made here. Last week when we were doing my sons paper route we noticed three white vans with Nebraske plates pull up in front of the...
Guess the front fender patches were welded in crooked by the former owner of them. More rework. But I got an awesome deal on them and was expected so not even bummed about it. Just happy to have fenders to even work with.
Well finally getting projects done and out of the shop. C20 painted and delivered. Took cuda out to the daylight to see it again and get some measurements for the square tubing.
LOL! Ya I threw that out the window. No schedule anymore. But would like to have it done for next summer. Lots of mods to do. Havent even looked at it since 2 months ago. Need to start ordering more parts.
Ya I should have shopped around before I got mine. Very pleased with the quality but hardly no communication. Even ROCKAUTO.com was cheaper. Thanks for the info!
Normally a car name is earned by the owner or cars history. Tell us your name, occupation. nickname. etc... Example... We had a guy years ago had a 4 speed 68 bigblock cuda that hopped down the track. Car and owner got to be known as "BOUNCING BOB". A 66 valiant wagon owned by a fabricator known...
WOW! I cant believe its been 19 days since I updated this thing. Still working on the c20 because of a previous bad paint job. Paint wouldnt feather edge. Could use your finger nail to scrape it off like egg shells. Ended up stripping most of it and redoing a ton of bad previous mud...
I just had a nuclear stress test done. Little I.V. in arm for a short time and no more riding bikes till you tip over. I HATE NEEDLES!!!! But it wasnt that bad at all. Just had to lay there and took about 25 minutes. You will be fine if you do that one. Most hospitals are going that way now.:cheers:
Most likely solvent pop. Spraying the clear on before the base coat is done flashing off. I just D/A sand the clear with 420 then reclear. Hope they are not charging you. Sorry for the pan leaking. Have you restraightened the pan holes to make sure they are pushed outward and not towards the...