furrystump's latest activity
-
Yes agreed. I read this post a while back. But I do think I'd like to bump it up. I built motor myself but didn't measure how far in the... -
furrystump replied to the thread 360LA Clutch Fan.I have the MB clutch unit IIRC. Running it with a 68 pump. 3/4” from the original 340 A/C radiator.
-
furrystump replied to the thread 340 Head gasket.I think you’re running into “trying to get back to 10.5” it probably never was 10.5, higher that other LA’s? Yes, true 10.5 probably...
-
furrystump replied to the thread 360LA Clutch Fan.Are you SURE what you found is for an LA small block? Most of the clutches have slots. So unless the slots are not spaced equally, it...
-
furrystump replied to the thread Headers.I was thinking about ceramic coating my exhaust manifolds to cut down on under hood temps. Looking at the claims on the websites, it...
-
furrystump replied to the thread Solid Flat Tappet Valve Springs.I was required to run a “race” tire on drag week. It was the only 14” that would work.
-
furrystump replied to the thread Solid Flat Tappet Valve Springs.In competition I have to run this tire. Testing I run the M&H
-
-
furrystump replied to the thread Solid Flat Tappet Valve Springs.In competition F70-14 redline lines, last week testing was a 14” M&H DOT Musclecar tire. My limited converter flash, (3500) doesn’t let...
-
furrystump replied to the thread Solid Flat Tappet Valve Springs.Last weekend it ran a 11.24 at 119 with a 1.60 60’, but was with a M&H DOT race tire, not the required F70-14 redline So it doesn’t...
-
furrystump replied to the thread Solid Flat Tappet Valve Springs.My wide lobe separation helps with the exhaust manifolds.
-
furrystump replied to the thread 340 Head gasket.Summit has a nice calculator when you look a pistons. You need to know Bore Stroke Dome CC’d + or - zero deck? Chamber cc’s
-
furrystump replied to the thread Solid Flat Tappet Valve Springs.I’m running PAC 1903’s at 1.80 on this cam. Pulls through 7000 rpm 135 on the seat 340 over the nose
-
-
furrystump replied to the thread 318 with Edelbrok perfomer intake and 600 cfm 4 barrel, what headers please?.318’s are kinda their own special animal that a number of people have “been there, done that” on what the low hanging fruit would be. I...
-
furrystump replied to the thread 408 rebuild.Honestly, it’s just a number. In a well sorted car 500 hp will easily get you into roll bar territory. Not sure of your end goal.
-
furrystump reacted to B3422w5's post in the thread Is Bradenton Fl. going to get closed down by subdivision? with .Agreed. Get on a plane and look at all the unsettled land you can see on pretty much any domestic flight. Lots and lots of uninhabited...
