Recent content by holic_77

Tried to message but your inbox is full.

I’ll take them, message sent

Are these just 915s or 67 915 HP heads? Sorry, Im new to big block and curious? My fresh built HP 915 heads

hi

It was a couple years back and I can’t find the receipt sorry. They did a 8 3/4 housing shortening, center section rebuild and a disc router redrill to SBP. Was only about $350 for all if I remember correctly.

Babbitt bearing did my 8 3/4 Machine Shop | Auto Repair | Columbus, OH | Babbitt Bearing Co., Inc

Added more Creepers

I've been to several shows were nice cars pull in, walk around for an hour or too then leave. I hate paying too but this is an option.

My shop

Try Mike from @B3RE .

That's great you got good friends and got it going. I've had one friend help me out from time to time but it's hard to keep asking for help.

Everything was wrong and I’ll be the first to admit when I make a mistake or mistakes. Moving on… Starting fresh and working with Mike. 7/16 PROPER length studs, new quality rockers, proper guide plate positioning, and understanding correct push rod geometry using Straub Tech.

Nice

I'm on the phone with Mike now, thank you

I’m trying to stay positive when I’ve spent over $10,000 on this rebuild when it’s only a couple hundred bucks more to keep it going. my daughter loves this car and that is the adventure of it.