Recent content by JGC403

Thanks for the input. I haven't seen any chunks but when I dumped the pan out that I had the filter in, there was quite a bit of glitter. I know I'm going to abuse it, so I'm just going to get the rebuild kit. I already have a deep sump pan and a external cooler with a thermostat and fan...

Its been a while since I have posted, been working on other projects. Trying to get my 1995 Jeep Grand Cherokee going again and then I can finally start on my Barracuda. But anyways.... I was just going to install a Transgo reprogramming kit, the TFOD-HD2 using the gear command feature. When...

Fixed

Looking for a complete 10" front drum brake setup. I have 9" drums now and want to go to 10". I'm near Greeneville TN. Hopefully someone has something close. Thanks,

Is there a difference between the A- body kickdown linkage and B and C bodies? My car is a 1968 Barracuda that I am putting a 400 in. The Barracuda has a floor shift auto and I have the linkage for that part. The transmission and the linkage I have is from a 1968 Chrysler Newport that had a...

I wanted to have some extra metering rods on hand to tune with once it get it running again.

Is there an Edelbrock calibration kit that will work with a Carter AFB? The carb is off of a 1965 Chrysler 413. Seems like Edelbrock has a few kits that are specific to certain Eddy carbs just not sure if any off them will work with the old Carters.

Thank You

Ok so there are only 2 locations the selective snap rings or shims are used, one on the bearing on the input shaft and the other on the output shaft bearing?

When assembling the 833 the proper thickness selective snap ring or the shims that are available as a replacement for the snap rings are used on the input shaft after the bearing is pressed on and after the rear bearing is pressed on the mainshaft. Are they used anywhere else? The snap ring...

Thank you for checking that.

Yea, If you could do that I would appreciate it. From what I found so far, the only reproduction seat tracks out there are for the '70-'72. So there has to be some kind of difference if they aren't advertising them for the earlier cars as well.

I stumbled upon a thread that mentioned that the '68-'69 seat tracks are a little taller than the '70-'72 seat tracks but they didn't say by how much. Does anyone know what the actual height difference is? Thanks.

Do you think all 4 of the engine brackets are truck ones? Thanks,

No ideas?