Recent content by Mgc340

Intake sold $1400 for heads

Rocker arms sold. $1700 for heads and intake or $1400 for heads and $300 for intake.

Box cleared

I will clear it

I would be willing to separate if heads and rockers sell first. A lot of interest in separating the stuff which I’m open to.

Yes they’re both good and bad on. Oth versions. Not all blue plug heads were good either

They’re not the blue plug version sorry. And fyi the whole blue plug crazy is a myth. Just as many bad blue plug castings and the original. These have been pressure tested though.

More pics

W5 heads Fresh valve job and surface job Mopar intake manifold I have shafts and rockers I’m throwing in that should work. You will need stands. I don’t know what ratio rocker. I was told 1.6’s Heads have been pressure tested and are ready for valves and springs. The part numbers are in the...

It’s not cracked

Lol funny guy. Have to love key board cowboys. It’s not cracked wise guy. The cylinder is dirty and it has a scratch from my caliper. You interested in the block or just chirping your mouth?

I do have a timing cover but it’s listed with my r2 block for sale. If some one wanted the cover with this block it would be $300 for the cover with this block. I do have an intake that would work with w789 heads. No cam bearings but I was told it had 50 or 55 mm roller cam bearings which you...

Yes all 5 are grooved. I do have a motor plate I would throw in with the block. You can run w7, w8, or w9 heads and intakes for those heads on this block

Mopar R block 48’ degree lifters 4 bolt mains Wet or dry sump 340 mains Old nascar block Deck height is 8.990 4.065 bore that is ready for pistons $1600

Yes this is an R2 race block Small block that was made just before the R3’s 48 degree bushes lifter bores 340 mains Siemese bore Roller cam bearings I have a low deck timing cover for it Bore is 4.175 still have the cross hatches and should be able to run as is. Deck height I measured was 9.10...