Recent content by mrtillie

Are these molding available for a 68 with the chrome strip along the side rear window?

Those are the right casing #s for 1969 xheads. Let me know when u decide to sell. Can you tell me if they have a x by the plug holes. That is the important part.

Yes im looking for 69 date code.

Im planning on doing a 4 speed swap as well. I have a few parts but need to round up a few more before i start. Posting some pics of your project would be nice to see.

thanks for the help.

Im not sure where i should post this so i will try here. Im looking for a X head from 1969 for a 340 small block.

Ok i got it this time. The video is the first time it ran in over 2 years. Its still had open headers and was covered in dust.

She is back on the street. 360 small block dynoed at 475 hp. 350 gears and 727 trans. Here is a short youtube video of it idling. http://youtu.be/KOZ2lDdPRR4

This one is going to be for sale in spring.

Found a pic of the 67 when i raced it. The second pic was a couple days ago with a fresh paint job. Retired the 67 a couple of years ago and now im returning it to the street. Built a 360 with 460 hp and 470 ft lbs of torque. I will try and post the dyno video of the engine. Garth's 360...

My 360 street engine video on dyno made 460 hp @ 6100 rpm, 470 ft/lbs @ 4500 rpm Ready and waiting to be installed in my 67 Barracuda. http://youtu.be/mPtjoC0V6SU

Working on my 67. Have started to make this 11 second race car a street car again. Engine and tranny are built and ready to install. Worked this week on the body. My plan is to have it ready for spring and then list it for sale. I will also list my 68 R/T for sale at the same time and will sell...

67 Barracuda gopro in car pass. - YouTube

Well you got your wish!! Go Brad Keselowski Go Good to see the Dodge name going out on top.

Cool ride, Good luck this race season.