Muswagon's latest activity
-
Muswagon replied to the thread Some snags with my conversion.Sooooo, latest is the reverse rod will hit how I ran the x pipe… can’t win for losing but it’s a fun game none the less -
Muswagon replied to the thread Malwood underdash hydraulic kit for A-Bodies.Pedal feels very good. I was pushing it sitting on a milk crate as my car is still half apart, so should be even easier with a proper...
-
Muswagon replied to the thread 440/Schumacher/Borgeson.What width? I see several options and googling makes it worse lol
-
Muswagon replied to the thread 440/Schumacher/Borgeson.Are you routed crank to PS only, or water pump as well?
-
Muswagon replied to the thread 440/Schumacher/Borgeson.Anyone have an idea of what belt size? I assume I run a string to get my measurement, but curious if someone remembers what they used to...
-
Muswagon replied to the thread Malwood underdash hydraulic kit for A-Bodies.I was reading through the comments a bit. I get the reluctance of having the master under the dash, but for idiots like me it saved sooo...
-
Muswagon replied to the thread Malwood underdash hydraulic kit for A-Bodies.I just installed mine on the weekend and can confirm there is no interference. I drilled a hole through the oblong body plug which I...
-
Dumb question.... I am running an internally regulated power master or something alternator, and the factory wiring harness is taped...
-
Muswagon replied to the thread 440/Schumacher/Borgeson.I ground the ear on the engine to clear, and the header is about 1/8th inch away. She is tight. Again, I did not lift my engine much...
-
Muswagon replied to the thread 440/Schumacher/Borgeson.Cleared ok after I shimmed up engine a bit, still close against the header but not touching is not touching
-
Muswagon replied to the thread 440/Schumacher/Borgeson.For the money these things cost it is beyond unacceptable in my opinion. Of course I wait until Friday night to try it and they are...
-
Muswagon replied to the thread 440/Schumacher/Borgeson.Here’s a snag I didn’t expect. The pulley for the pump is not even close to being true. The outside is warped even worse than the inside...
-
Muswagon replied to the thread Some snags with my conversion.Yes that’s exactly what’s called for, but seeing it installed is unsettling for lack of a better word
-
Muswagon replied to the thread Some snags with my conversion.Ok so ready to testing but something does not look right. I measured my air gap about 10 times. With it installed, there is a space...
-
-
Muswagon replied to the thread 440/Schumacher/Borgeson.If the pickup biscuit is thicker it would for sure change the amount of shims, but not sure if the studs are oriented the same. I had...
