Recent content by MZimmerman

HELP!!! I put a new Borgeson Steering Box in my 71 Valiant. It has had some play and needs adjusted. Everything under the car is new and there is definitely play in the box. My problem is that with the retaining nut loose, I can not turn the adjuster screw, it simply will not turn. I've got...

Ahhhh. You are right, the expansion valve screws on there. Got the tubing brazed together and have the crimp tool. THANKS!!!

Hello. I am working on converting my R12 to 134-a... Wasn't an AC car before. 71' Valiant 360. Everything is installed except hoses which I just got. Cut off old hose and got Beadlock fittings for new hose. High side should be OK. although I burned a hole in the tube trying to un-sweat the...

Hello, I am replacing hoses on my Valiant A/C to convert to 134-A. What are the sizes of the hoses? I think the High Pressure is #8, 1/2" and Suction is #12, 3/4"??? Thanks

So.. I am still in need of the Hose running from the Compressor to the Condenser. Any luck out there?

Done.

Thanks, What are you thinking for the one with the muffler, shipped to Tiffin, Ohio 44883

These are the ones for the Slant 6. This hose is the one from the compressor to the Evaporator. The top horizontal length will be almost 0", or I guess the bottom leg length could be a lot longer??? May or may not have a muffler. This one is the one from the Compressor to the Condenser. The...

Sadly I do not have them, but I do know that the one I need from the condenser to the Compressor (smaller diameter and has the two bolt ear attachment to the front of the compressor) has about a 18" section of flex hose where as the slant has about an 8" section of flex hose. The larger...

Well... It is a 71' Valiant with a 360. Had a Slant 6, Upgraded to a V8.

In need of both compressor hoses for my RV-2 Small Block. One to Condenser, One to Evaporator???

Hello, Looking for A/C Hoses for 71 Valiant with a 360. Thanks

OK, so just to be clear, i can order a Square Bore Edelbrock or Holley Carb that will bolt right up to my existing 340 Intake that has smaller primaries?

What about a Demon 1904?

Ok. Thanks, Learned something new :) Always considered smaller primaries being a spread bore. So, now that we have that straight. Recommendation??? I will check on the cross over gasket, not sure which set I put in when I rebuilt it. Either way, still looking for a new carb.