Recent content by Rice Nuker

Yea, that dude died b4 17 years old. He got a pontiac cyl head to the back of the head. Apparently you shouldn't drive with engine parts in your car and hit a tree.. Not sure if he knew everything but who does at that age or ever. Ported vacuum from my understanding is venturi signal based. So...

Because of America -- F Yea

Following up, does anyone know where to get the main well caps that glue on the base of the carb body? Thanks !

Hey All, My previous sale thread expired or similar. Added pics here. Great to Excellent condition. I sand blasted it really clean and painted with aluminum color wheel paint. My 360 has too much cyl wear so going to use a magnum motor. Selling my LA stuff. 175 plus shipping. Ship from...

Hey thanks Golden.. That is great info! I thought mine was irregular but glad to hear the large tubes can be a bit different from side to side. Yours looks like mine. Regarding the air bleed tubes, guess I will get a super small bit and put a thru hole at the same height as the other one and...

RRR, would you be able to sell me a couple good main well caps?

Hey, thanks :) yea so I used coarse blasting soda and a harbor freight hand blasting unit shown above. My compressor is a beast but I have seen folks rig up a soda blaster on youtube and use a box of arm&hammer on a motorcycle carb with a small compressor. I tried the blaster rig shown on...

rumble, I did look alot and it is very clean, there are no holes in the drivers side emulsification tube and different location but actually same number of holes in the fuel output tube, just different locations. I did see the output tube has a hole in the very end on the drivers side. You can...

So, I see a discrepancy in the secondary fuel feed tubes and air bleed tubes. Is this normal? Looking the way the camera sees, the left fuel output tube has fewer holes and the air bleed brass tube has zero holes, I have looked over it completely. Can anyone shed light on this? It is a 9801...

Anyone recommend a good source for a complete kit? I looked on ebay and walker industries but ebay kits dont have floats or well plugs and walker has several things out of stock including well plugs.

Thanks for checking it out :) Could anyone recommend a good rebuild kit / source to buy? Also, I need some good well caps or at least 1 because I lost it in the gravel when I was blasting the bowl. They both totally fell off. Sure they were not glued on at all anymore.

GBA

Hey Fabo good people, Just refurbishing my TQ. Always wanted to do such. It is a *9801S. Summary: Sat outside under a tarp (on the motor) and got sem-rained on for 4 years. Got back into it. Set up electroplating process and already have a big compressor / hand held blaster for coarse SODA.

Hi, These are new production, not old. They have been run for about 1000 miles before we had the factory VCs redone and put them back on. Attached is a pic taken from summt. Ill pull them from storage and take pics if anyone has some interest. Quality is good to great. 150 plus shipping...

Hey All, Selling this unit. Great to Excellent condition. My 360 has too much cyl wear so going to use a magnum motor. Selling my LA stuff. 200 plus shipping. Ship from Folsom CA area. Anyone interested, I can get pics and post on here, it is in storage. Just PM me! :) Thanks Fabo people.