Recent content by Scat

New never ran Borgeson power steering box. 14 to 1 ratio. 1.25" pitman arm. Comes with the adapter needed for the column. Went to coil over suspension, no longer needed. La Crosse Wi $650 Buyer pays for fees and shipping.

Pair of used TTI headers pre dented for 73+ mopar stock k frame with spool engine mounts. Set of TTI gen 3 hemi motor mounts spool type for small block k frame. Oil filter relocation parts to move oil filter. Comes with lines, filter housing, and block off plate not pictured. Went to coil...

I have a set of mounts still on a K frame here. No centerlink though.

my brother did for a persons car a while ago, wont work with stock K frame.

73 duster

gen 3 Hemi.. with headers.

Well is it possible or would it be best to just drop the k frame?

Well got some work to do now.

18x9 with +35 offset

2012 vvt motor

DO you by chance sell the gen 3 hemi pumps or have a source? Thanks

I’ve always had a soft spot for Enkei wheels ever since a friends EVO had them soo I joined the gang

I’ve thought about going with an electrical ps set up but as of now I have the 20 to 1 manual box. If I were to go with the borgeston box being I have manual I would just shorten the shaft and red roll for the pin. Curious if anyone would know about the Hemi running higher power steering...

What are the go to box’s out there? I know most people swear by the borgiseon box. Needs to be the smallest possible box due to gen 3 Hemi and headers. 73 a body is the car. Thanks

well I splurged a little bit.. Wheels are ordered but in the need of updating and treating myself. I got the full cobra disc brake set up from Dr diff Front and Rear. Got everything to redo the rear axle for a B body plus a tur trac sure grip with some 3.91 gears to go with it. Plan on...