The Edelbrock Performer 1404/1405 carb float bowls are known to evaporate dry after about 3 days of sitting. I have two of them, I looked into this problem and it seems to be a common problem. The bowl vents allow the fuel to evaporate right out of the bowl. Mine starts fine when warm, but...
For the record, here is a link showing available electric car chargers across the US and Canada. Actually worldwide. Click on any pin to see what type of charger. The orangeish ones are Tesla Superchargers. And to answer an earlier question there are 3 Tesla Superchargers in South Dakota...
I don't know what an R block or X block is, not that knowledgeable. But I saw no mention of the block being used in the Hellcat, or comparison of that engine to the LS engine.
To close the loop on this, the correct idler arm was Moog K7086 for '73+ Dart, etc. It has "7324-C" cast into the part itself, both the old part and the replacement part. This is the bottom idler arm in the picture I posted earlier.
To close the loop on this, the correct idler arm was Moog K7086 for '73+ Dart, etc. It has "7324-C" cast into the part itself, both the old part and the replacement part.
I have a Big Green Egg. My buddy bought a Pit Boss pellet grill, the smaller one. He had a couple complaints, as I recall it did not come with slotted plate that would keep your meat away from direct flame, so can't do indirect cooking. And no way to dump the unburned wood pellets to easily...
Are you guys still around? I have the same problem fredsmedina had 7 years ago. My '67 Barracuda pitman arm has the identical "7324-C" marking on it; my steering assembly has also been replaced and I have not figured out what it came from. Tried Moog K7066 for '73+ Charger, it is so close but...
Thanks, Kiss and 67Dart. The 73+ may make sense because the idler arm in the 73+ picture looks like mine. Also because the engine swapped in is a 360LA small block which I think came from a '75 Charger. Would that engine swap require a k-member swap, which would lead to using the idler arm...
The suspension on my '67 Barracuda was modified by a previous owner, and I have no records for what was installed. My idler arm is worn out. I discovered on this site it does not use the original '67 idler arm because mine has a through-bolt to attach to the frame tabs. I thought it would be...
Wow, I did not expect such a fast reply! I had heard of the mod you refer to. So you think someone welded up the bracket to allow using the 68 up idler arm? Thanks again!