Recent content by swies

Subscribe d

PM SENT.

Zero

I have checked the pump repeatedly. It is an Edelbrock 1720 and the check valves will hold for days. I don't HAVE to go electric. I am just thinking the electric will 'prime' the carb when I do want to start it after 3+ days. By using the lp/lv pump, it won't over pressure the needle valve but...

I am sure it is evaporating. After investigating, I noticed the pressure gauge shows nada. Pull the Carb top and the bowls are empty. Crank, crank, crank (5-10 secs) pressure comes up, 10 seconds later it fires. I have checked backflow and cant find any. I believe when I shut down, the fuel in...

318 +.030 Zero decked KB167 RPM AG Eddy 1405 W/ 1” phenolic Eddy mech fuel pump Stainless fuel line insulated in the entire engine compartment I suffer from the warm start issues and when I open good, my fuel pressure gauge shows 0 and the bowls are empty. I have read on this site about...

Pictures would help alot....

Yes they do.

I cannot say if they do but, I can say I have recently made a purchase from them. Bought an electric choke conversion for my Edelbrock. Price was the same as eBay, jegs etc and shipping was darn fast! I will recommend for sure.

Hey! Easy on the Beaks!

Gotcha. Thanks

I see. Many including myself have used the “T” in the factory location. Makes life easy. Wiring is smooth and hidden with the main harness. Picked my “T” up at Home Depot for $2.49. Took about 10 minutes total. In the other case, if your adapter is insulated by gaskets it will not work. The...

Use the “T” fitting like mentioned above. Quick and easy and keeps all the wiring in the same place. Not sure how you installed it at the filter adapter. Did you drill/tap it?

Embrace The BEAK!!

I will say it again.