I won't pull the distributor unless you not sure it in right. Check the wire you getting 12v from. Make sure it's has 12 all the time the key is on. Or find the two wire that feed the ignition and put the on the coil.
If it ran on a stand it should run in car. If you didn't remove any parts to get it in. I would check your wiring. Does it only want to run with the key in the start position?
I own a 67 Barracuda and at a show this past friday I saw a 69 conv there. I have been going to this show for the most part every friday from mid summer last year. I was talking to the own and he asked me if i knew what was on his dash. It looked like a cig lighter but its to the right of the...
If you register as antique you don't need a inspection sticker. But it can't be your daily driver. If it looks all there with factory stuff the boys in blue shouldn't bother you. What part of Maine are you looking at?
Also check out this valve
OVERFLOW VALVE
Fuel volume from the fuel transfer (lift) pump will always provide more fuel than the fuel injection pump requires. The overflow valve (a check valve) is used to route excess fuel through the fuel return line and back to the fuel tank. Approximately...
How far away is the dealer from you? There is a tool that plugs into the VP44 pump that will run the engine. THe tool number is 3163834. It will give you a hi/lo ldle and shut off. When I did the diesel work at my shop I loosend all but number 6. The VP44 pump will some times not like to bleed...
I have a 67 Barracuda notch back. I'm looking for pictures of the trim that hold or finishes off the headliner by the doors / roof line. Or if any body knows where I can get some. I have the A-pillar trim. Thanks for any help.