Recent content by terry

i'll take a set, tired of my mess when setting float

great idea and does everything you say. it has to be a great stocking stuffer

looks nice. track time ?

yep i bought 2 of them. one for the car the other for the lawn mower

yes i agree i prefer no choke ,but how hard would it be to remove the electric choke ?

sorry the brand is FST

has anyone used one of these carbs or even heard of these? i see them on e-bay and their prices seem lower then other brands.

yes it bothers me but I did find that with a test light I get the blinking coming out of the fuel gauge circuit board stud that travels to the temp harness pin. in fact I think I have 3 studs that are blinking and 2 others that are hot. I just may start at square one and us a volt meter on the...

thanks for everybody's great input. well today with the help of a service manual I traced the 2 wires ( oil pressure & water temp) thru the bulkhead (still blinking) up to the round connector that fits into the circuit board for gauges. the wires did blink as I tested them in the round...

yes mine do look like those but they are the original gauges. my after market gauges are both mechanical style. and work fine.

well I have after market gauges on my 68 barracuda and never tried to hook up these 2 gauges. amp and fuel gauge work fine. but the temp and oil pressure gauge will give a test light a blinking light when I connect the wire to the test light and the key on. if I leave the test light connected a...

mine was maybe 2-3 months. might I add the plugs are very black from the last 200 miles. but the car runs very good. so just thought something might be getting gummy from letting it sit.

the last time I checked it was 16 and 36 total I believe.

hi folks I have a holley 750 on my magnum 360 that just fouls out the plugs and runs terrible. if I turn the air/fuel mixture screws in all the way it smooths out. I didn't put a vacumm gauge on it to see my readings yet. I don't drive the car much so if its dirty could I just remove the screws...

hi folks does anyone know the manufacture that mopar used for there clutches and pressure plates in 2003? I have a p4529136 clutch and p4529140 plate but I just can not remember the manufacture .I did get them from a Chrysler dealer. thought it was center force. thanks