**Twin Turbo 67 Dart Project**

Well I started the mock up of my GT45 Ebay turbo's. I will try and document everything that I can and take alot of pictures.

As most of you know, I have already done a Triangulated 4 Link, mini tub, and the back half of the cage.

My Set up will be a 410 Small Block Mopar with 9:1 Compression using RHS INDY X Heads, The motor alone should make about 500HP at the crank, 2 GT45 Ebay Turbo's, 2 60mm Wastegates, 2 50MM Blow off valves, Block Hugger Headers to keep the cost and fabrication to a minimum, 2 air/water intercoolers, 1 mounted in each front fender well, a heat exchanger mounted up front with 2 10" Fans and a closed loop ice box in the trunk for race purposes. I will also be using an AIS Stage 2 Meth injection kit with multiple nozzles. I am shooting for 700-800RWHP....................

As of last night I have 1 Turbo mocked up so far. I hope to have the other one done by this Saturday!

This is the car on the ground after a home built Triangulated 4 Link and Mini Tub, Disc Brake conversion.

View attachment IMG_1564.jpg

This is the rear of the cage tacked in ready for my buddy to come over and finish up the front half of the cage. I don't like the kits how they come in the cockpit area, he will turn it into a 12pt. Nicely tucked thru the dash etc.

View attachment IMG_1614.jpg

View attachment IMG_2019.jpg

View attachment IMG_2020.jpg

View attachment IMG_2021.jpg

View attachment IMG_2022.jpg

I had to remove the pan and I notched the corner of it instead of cutting the K FRAME, I am drilling tapping and welding the Turbo Drain Bungs into the new Beautiful Milodon pan anyway................soooooooooooooooooooooooooo

View attachment IMG_2025.jpg

View attachment IMG_2023.jpg

View attachment IMG_2024.jpg







Here we go!