Specs please

Thanks for all the replies.

Got my block and head back yesterday and measured it. The head is 56cc's and I have .170 deck clearance. Crunching the numbers and accounting for a much thicker head gasket. Stock .022 new one .042. with a .010 cut on the head to clean I can take .085 off the block to bring it to 9.45 to 1.

Question? Wht would you take a half and half cut. My thought would be to take more off the block so it is not firing in an open space. Trying to get as much into the head would be benefical considering the head doesn't have a very good quench design.

As far as pushrods I'm not to considered. I have heard that Hemi rods are close. Or i'll cut them down and put new ends on. I haven't picked a cam yet I may go with some ultradyne cam. Exhaustwise, I would like to stick with a stock apparence so haven'e figured that one out yet. Intake, I will use a 2 bbl w/ primary, secondary.