bottoming out

I would reccommend using a torsion bar tool, you can buy them at manciniracing.com, you just clamp it to your torsion bar, remove the C clips at the rear, and hammer on the tool and out come the torsion bars. Remember to first put the car on jack stands, and totally loosen off the torsion bar adjuster bolt, which can be found in the bottom side of your lower control arm. Replace with new torsion bars, use the tool to hammer back in, replace dust boots and C clips, and make sure to grease them up while hammering in. DO NOT use a pair of vice grips, as they can scratch the torsion bar badly and could splinter and blow up.