down under 318 stroker build
over the last few months ive been building my 318 stroker
finially run it up today and ran the cam in, so happy sounds wicked.
heres the specs
318 block bored .030 with oil galleries modded
4" scat forged stroker crank
h beams
kb forged pistons
all balanced
edelbrock ally heads lightly ported
11.7 compression running on pump gas
mopar .557 solid cam
crane 1.6 rockers
hv oil pump
milodon sump and pick up
super victor intake
750dp demon
tti made RHD step headers
straight cut timing gears
full msd ignition once it goes in the car
heres the engine and a couple of vids from us running it up this arv after cam was run in
http://www.youtube.com/watch?v=SFX7y2gv ... e=youtu.be
http://www.youtube.com/watch?v=XPKq0E_2 ... e=youtu.be
and heres the vehicle its going in 1975 valiant ute
trans is a 727 with a 4000rpm stall and 8 3/4 rear with 4.1 gears
should be fun
cheers
Ash
over the last few months ive been building my 318 stroker
finially run it up today and ran the cam in, so happy sounds wicked.
heres the specs
318 block bored .030 with oil galleries modded
4" scat forged stroker crank
h beams
kb forged pistons
all balanced
edelbrock ally heads lightly ported
11.7 compression running on pump gas
mopar .557 solid cam
crane 1.6 rockers
hv oil pump
milodon sump and pick up
super victor intake
750dp demon
tti made RHD step headers
straight cut timing gears
full msd ignition once it goes in the car
heres the engine and a couple of vids from us running it up this arv after cam was run in
http://www.youtube.com/watch?v=SFX7y2gv ... e=youtu.be
http://www.youtube.com/watch?v=XPKq0E_2 ... e=youtu.be
and heres the vehicle its going in 1975 valiant ute
trans is a 727 with a 4000rpm stall and 8 3/4 rear with 4.1 gears
should be fun
cheers
Ash
