**Coil Over Conversion with Stock K**

Mad Dart said
To drill out the spot welds it only takes a few minutes. I had the stock support on the ground in less than 15 minutes.

If you do that you will need to cut the legs down a bit on both sides so it does not hang lower than the stock assembly. It might look kinda weird if you seen both of them from the front view? Just something to think about is all.

ok kool, ill just take it out.

again, very nice job louis! everything looks professional. for the radiator support, did you use like a blair spot weld cutter? i need to get one. also, on the 70 darts, it has 2 more ears on the support for the front valance, which is no big deal, ill just make new brackets for that.