Edie: The Dart
Next is sail panel area, nothing too magical here, I cleaned out all the old filler, which was not very well finished and looked crappy.
Both sides were close to being the same alignment, I was concerned on the drivers side because there was a big belly about mid-way along the sail upper area shown below, but after relief cutting, tapping around on it, then re-welding it I got it close. Now filled in, it looks great.
I used everglass to fill in the seam, its nice stuff, easy to sand, but even with a mask I got a horse voice from it.
Filled in on both sides.
Finishing it up with body filler, both sides have been quite tedious to finish, it looks good though!
A little finishing, and a little floating and I'll be done. More next week.
Next is sail panel area, nothing too magical here, I cleaned out all the old filler, which was not very well finished and looked crappy.
Both sides were close to being the same alignment, I was concerned on the drivers side because there was a big belly about mid-way along the sail upper area shown below, but after relief cutting, tapping around on it, then re-welding it I got it close. Now filled in, it looks great.
I used everglass to fill in the seam, its nice stuff, easy to sand, but even with a mask I got a horse voice from it.
Filled in on both sides.
Finishing it up with body filler, both sides have been quite tedious to finish, it looks good though!
A little finishing, and a little floating and I'll be done. More next week.
