With the new distributor, it still goes through the resistor. When I get more time, I will find a way to get a keyed hot to go to the coil. So maybe the first module is ok then? [/COLOR]
Same guy I bought mine from. He gives good info in the ebay listing. It clearly says to get rid of your ballast resistor. It also works best with an E-core type coil. Your factory coil will likely over-heat if you try to use that. If you must have a round-can type coil, get an MSD Blaster or such.
The simplest way to bypass your ballast is to use a double-spade connector to connect the 2 terminals together (without the ballast). They are a bit hard to find, so you might have to crimp 2 male spades to a wire. If so, use 12 or 14 awg wire. Cover with heat shrink so no metal can short.
