**Twin Turbo 67 Dart Project**

I made a little bit of progress today. I ended up pulling the 3rd Member and got it ready to ship out. All the measurements for the Brackets are done and I made some templates out of Chip Board. I bought a 18x18x1/4" Chromoly Plate that will get cut up to make the brackets. I did the Instant center calculations today also. The bottom bar will have 4 adjustment points Front and Rear. The top bar will have 3 adjustment points on top of the housing and 5 adjustment holes in the front. This will give me plenty of adjusting of Instant center from 18" off of the Rear tire to out past the front bumper in 6" or 12 " increments. The Instant center off the gound is adjustable from 5", 8", 12" etc up to 3' or so with all the combinations. My Initial set up will be about 1' back from the front tire either 5" or 8" off the ground and I will play with it from there.

I put a big fill cap on today and a drain plug also. The back brace will go on after all the Bracket Tabs, then everything will get welded off. The housing ends will go on last with the use of Housing End Jig. Waiting on the new link bars and Heims to get here. Along with the New 9" 3rd Member. Making little bits of progress which is better than nothing.

View attachment phpygDOK5PM.jpg

View attachment phpbIko97PM.jpg

View attachment php1UxNxhPM.jpg

View attachment phpLgg524PM.jpg

View attachment phpuH1Kz5PM.jpg

View attachment phpJvHNHfPM.jpg