Snapes 73' Dart Resto

I have a question about these bushings i pressed into my LCAs
Both are solid on the outer shell, i cannot press anymore.
HOWEVER
one of the piviot arms "collar" above the bushing is only 1/4" from the inner bushing shell.
the other is 3/4" from the inner shell.
If you look from TB side, the 1/4" pivot arm is pressed all the way up against the torsionbar opening
the 3/4" has a gap between it and the TB opening.

Which is correct? Did I over press one? did I under press one?

I will attach pics to better explain my issue.

if need be, i'll press both back out, cut off the bushings, and start new.