Some alignment help needed please.

Well,I did it thanks to all you guys here on fabo.The info you gave was dead on and made alignment a breeze.I do have one more problem though and need some help getting pointed in the right direction.First I set the height of the vehicle by adjusting each arm to 1inch between the bumpstop and frame.Now comes the problem.The right side of the car was still over half an inch lower than the right side.So I adjusted the right side until the car sat even as measured from various points.On the right side of the car I followed the instructions for setting caster/camber and was at -.5 degree camber within probably 5 minutes.Easy I says.Go to the driver side,adjust front bolt out,rear bolt in,and camber is at-3.3.The best camber I could achieve was -2.2 with the rear cam bolt all the way out.So I adjusted the rear bolt back in and I'm back at -3.3.Car drives fine and tracks straight ahead.Do I forget about the car being level and adjust the bumpstops so they are equal lengths and try again? I looked underneath for any bent parts to the k-member and such but it looks fine.So now what do I do?Thanking you in advance......................Bump