pushrods with or without oiling hole?

I have
1977 360 from a van. very low compression.
Block decked, its been like 20 years ago and i cant remember if it was .040 or .060 off the block (.060 i think) and I took .020 off the head. to get 9 1/2 or so compression. with a mild cam.

now
I had my heads reworked and I'm looking for push rods.
i can find almost any length push rod with oiling holes. solid tips are very limited. the answer in this thread. is not very clear. a while back I bought stock lifters from the auto parts store. they have the hole in the top of the lifter.

it sounds like i can use ether just want to make sure. if so i will check to see i loose any lift.
thanks