EZ Wiring Mini 20 Circuit Installation

I also installed this harness setup...http://www.forabodiesonly.com/mopar/showthread.php?t=207159

For the steering column (Igniton switch and wiper switch) You'll need 11 if the 0.093" male terminals, and 5 of the 0.125" terminals. They are in the interlocking connector drawer there. This will allow you to re-pin the factory connector bodies. If I need to change the switch, I can just put a brand new one in off the shelf and don't have to modify anything.

For the headlight switch, I remember branching out the B+ to 2 or 3 different pins on the switch. I just soldered and heat shrunk it.