EZ Wiring Mini 20 Circuit Installation
goldduster318 your thread gave me the idea of where to mount the fuse panel.
Today I have made some more progress. First my fuse panel bracket didn't fit as I hoped. Had to cut and mount it slightly to the left.
The kit.
This is how I mounted it first but the dash cluster would touch the fuse panel then.
Brum brum with the grinder and fixed the problem.
Then mounted it slightly to the left to clear the dash cluster clearance problem.
Oh no the car is sick and puking wires :)
Used hockey tape to wind a bit of the tail harness wires.
Then I put the wires in this flex tube.
And finally I came there with the wires.
Instead of route a new ground wire to the dome lamp. I'm planning on using the third brake light wire(the tagged one) that's already routed with the tail harness.
Some of the previous owner had wired the backup light to the tail light.
Used some shrink butt connectors. Worked really good.
Now it's right again and with fresh terminals.
Some tools for the job.
Made this plate for the firewall and used a new gasket which is for the old bulkhead connector.
Became quite good I think.
Now the spaghetti mess is back.
goldduster318 your thread gave me the idea of where to mount the fuse panel.
Today I have made some more progress. First my fuse panel bracket didn't fit as I hoped. Had to cut and mount it slightly to the left.
The kit.
This is how I mounted it first but the dash cluster would touch the fuse panel then.
Brum brum with the grinder and fixed the problem.
Then mounted it slightly to the left to clear the dash cluster clearance problem.
Oh no the car is sick and puking wires :)
Used hockey tape to wind a bit of the tail harness wires.
Then I put the wires in this flex tube.
And finally I came there with the wires.
Instead of route a new ground wire to the dome lamp. I'm planning on using the third brake light wire(the tagged one) that's already routed with the tail harness.
Some of the previous owner had wired the backup light to the tail light.
Used some shrink butt connectors. Worked really good.
Now it's right again and with fresh terminals.
Some tools for the job.
Made this plate for the firewall and used a new gasket which is for the old bulkhead connector.
Became quite good I think.
Now the spaghetti mess is back.
