AlV 69 Dodge GTS project
Some of the things I took away from doing the work on the drive line and brakes..
Diff case cast = 2070741
Diff and pinion yoke U-joint cap size = 1.124
Diff center = 8.75 w/ New MR. Gasket seal.
Diff Gear ratio = 3.91 w/ Sure grip
Slip yoke = 29 spline
Drive shaft = 48" L x 3.25" Dia.
Brakes = Rear are 10" w/1.75 shoe
I spent a little more time poking around and found some interesting things, some scary. Some of which are items that are going to be a bit more involved than I thought. Makes me feel like tearing down the car and doing a ground up overhaul. lol
These are photos of the damaged starter motor, under dash bulk head connector and speedometer cable. The start motor terminal insulator is broken but the starter is still functioning. The Bulk head connectors are notorious for over heating and the speedometer cable was poorly routed and was touching the exhaust which burned through the casing (I'm hoping that's why the speedo wasn't working).
Starter damage
Damaged bulk head and 10 Ga.splice under the dash
Damage to speedo cable
Next step is to fix the starter, dive deeper into the electrical harness and replace the speedo cable.
Some of the things I took away from doing the work on the drive line and brakes..
Diff case cast = 2070741
Diff and pinion yoke U-joint cap size = 1.124
Diff center = 8.75 w/ New MR. Gasket seal.
Diff Gear ratio = 3.91 w/ Sure grip
Slip yoke = 29 spline
Drive shaft = 48" L x 3.25" Dia.
Brakes = Rear are 10" w/1.75 shoe
I spent a little more time poking around and found some interesting things, some scary. Some of which are items that are going to be a bit more involved than I thought. Makes me feel like tearing down the car and doing a ground up overhaul. lol
These are photos of the damaged starter motor, under dash bulk head connector and speedometer cable. The start motor terminal insulator is broken but the starter is still functioning. The Bulk head connectors are notorious for over heating and the speedometer cable was poorly routed and was touching the exhaust which burned through the casing (I'm hoping that's why the speedo wasn't working).
Starter damage
Damaged bulk head and 10 Ga.splice under the dash
Damage to speedo cable
Next step is to fix the starter, dive deeper into the electrical harness and replace the speedo cable.
