Floor pan and quarter patch help needed.

On the floor pans Make sure you dont over cut. IE new panel test fix and mark before cutting old one out . Once this is done from bottom of car drill guide holes 1/4 inch away from supports so you can remove old piece first this way you can use wire wheel on grinder to remove paint from left overs of old floor panels by drilling out spot weldes and carefully prying left overs from the rest of old panel leaving sub frame in tack.


http://www.forabodiesonly.com/mopar/showthread.php?t=256891&highlight=replace+floor+pans link for pan removed frames showing not my car I have done this my self but never taken photos

once it looks like this use grinder to remove surface rust then prime frames with weld through primer you can buy buy from body shop supply or welding store. Then fit new panel then from under car mark panel with sharpie so you can drill holds for welding pans to frames where old spot welds were. You can hold floor temporarily with pop rivets or clecos. Hope this helps.